High voltage feedback measurement

Status
Not open for further replies.

Akwasi

Newbie level 6
Joined
Aug 12, 2012
Messages
12
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Visit site
Activity points
1,371
I have a converter with 1kV output voltage which charges a 47nF capacitor,
to measure that voltage I'm looking for a solution as an alternative to a fixed resistor divider to let the capacitor store the charge as long as possible, >1sec,
I thought about taking sample measurements at intervals, for example to use a MOSFET to switch the resistor divider off between the measurements,
but all the MOSFETs I see are specified below 1kV,
maybe an option would be to put some z-diodes in series with the MOSFET, but does this really make sense ?
I assume that even with the Z-diodes in series the MOSFET will still see the 1kV in off-state,


any ideas ?
Thx, Andreas
 

agreed, the 500M resistor is a valid solution, in series with a 1M the 1kV would result in 2V, but I'm still looking for something that does not constantly drain current from the capacitor
 

Status
Not open for further replies.

Similar threads

Cookies are required to use this site. You must accept them to continue using the site. Learn more…