high pressure cabeling

Status
Not open for further replies.
V

vamsee

Full Member level 1
Joined
Nov 6, 2012
Messages
95
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,885


Hi all!! the picture shows the attachment of my magnet to the ball valve and placement of hall sensor...

I need to house or cable the hall sensor, such that it withstands 100 bar pressure and 200°C temp. the cabel should extend about 2meters, so that it reaches my Data Acquisition board.

And is there any high temperature adhesive to stick my magnet to the ball valve (other than sticking, new ideas also welcomed to share with me)..

If u need further details, pls ask..

thanq
 


thank you for the reply.

I have selected the hall sensor because it has high operational temperature.. **broken link removed**

yes u r correct, it is to find the position of the ball valve.. I need to know how the wires should be cabeled so that it can withstand 200°C and 100 bars..
 

According to the datasheet this device can only work up to 150 deg C!!
And it is a PCB mounted device (SMD or TH) that requires a fairly large polarized decoupling capacitor. Without active cooling and mechanical protection it will never withstand 100bars and 200 deg C.

Check the link from my previous post. This is the device you should look for. It is sealed and protected by a metal enclosure. Still 200 deg C may be a problem.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…