High power smd led pad design and routing

Status
Not open for further replies.
Have you something called "route offset" (or similar) in the settings?

If not then add some copper to the pad so that the route comes into that, stopping before the pad perhaps?
 
Thank you Mattylad.

I tried adding copper to the pads but it takes lots of times. I use 48, 75, maybe much more LEDs on pcb. Is there "route offset" (or similar) setting in Altium?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…