yefj
Advanced Member level 5
Hello, I am trying to manufacture a component at 35GHz, its rogers6202 5mil width.
0.274 is 50ohms.
In the simulation its all good and ideal, but in real life there could be problems.
If you could please give me advice regarding the following points:
1.How to choose a proper connector for 35GHz?
2.Tips for a proper transition from connector to the trace?
3.Things in manufacturing that could ruin the performance and how what counter measures to take?(etch factor ,non uniform dielectric constant)
if there are other tips I'll be glad to hear.
Thanks.
0.274 is 50ohms.
In the simulation its all good and ideal, but in real life there could be problems.
If you could please give me advice regarding the following points:
1.How to choose a proper connector for 35GHz?
2.Tips for a proper transition from connector to the trace?
3.Things in manufacturing that could ruin the performance and how what counter measures to take?(etch factor ,non uniform dielectric constant)
if there are other tips I'll be glad to hear.
Thanks.
Last edited: