trichop
Junior Member level 3
I make a model in HFSS where I use a lumport to feed a microstrip. The microstrip is placed in an empty conductive 3D ellipsoid.
1)After I start the analysis an error message appears saying:
The gap source will be short circuited by the conductors...
but I can't understand what it means, because when I simulate the microstrip alone, without putting it in the ellipsoid, everything goes well.
2)A warning pops as well, saying:
[warning] Solution Setup 'Setup2': Given the specified frequency and model dimensions, an extremely large mesh will be required to produce an accurate solution. Your model and/or frequency units may be set incorrectly.
could anyone help?
Thanks in advance.
1)After I start the analysis an error message appears saying:
The gap source will be short circuited by the conductors...
but I can't understand what it means, because when I simulate the microstrip alone, without putting it in the ellipsoid, everything goes well.
2)A warning pops as well, saying:
[warning] Solution Setup 'Setup2': Given the specified frequency and model dimensions, an extremely large mesh will be required to produce an accurate solution. Your model and/or frequency units may be set incorrectly.
could anyone help?
Thanks in advance.