Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Help Needed on proteus simulation

Status
Not open for further replies.
manoj madhavan

manoj madhavan

Banned
Full Member level 1
Joined
May 1, 2010
Messages
119
Helped
5
Reputation
10
Reaction score
5
Trophy points
1,308
Location
India, Kerala, Moolamattom
Activity points
0
I have a proteus stepper simulation...... Simulation was OK.... But practical is not working...

please take a look at the attachment..

It has Forward, Reverse and Stop function...... connected to the P3.0, P3.1 and P3.2 also...
The out put was P0.0 for Forward, P0.1 for Reverse and P0.2 for Stop...

Reverse and stop function are okey...But no change when I press the Forward switch P3.0 connected via K1.

I am so worried about my project

Can you help me any one please..?

Thanks in advance
 

Attachments

  • Stepper.rar
    29.3 KB · Views: 57

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top