Hi,
Some commeents about your post in general,
A forum is meant that many people gain information from your post.
Thus your headline should be a short description of the real problem. Otherwise no one finds your post ... and maybe starts a very similar thread.
These thinkecad schematics are hard to read - at least for me.
I know thinkercad is used by many hobbyists. But they do it a very unprofessional way .... and teach you thing that you need forget later when you become more professional. Thus I recommend to learn to do it the professional way ... to avoid to need to learn things twice.
(Sadly) In opposite to simulations, in real world a capacitor at VCC is mandatory in most cases. Thus I recommend to add this in your achematic, so you can' t forget to add it on the real circuit.
The proteus schematic has low resolution, thus the values are hard to read.
The wiring of the thinkercad is unnecessarily difficult ... and due to crossing of same colored wires hard to read.
Example: pin 8 of IC is VCC, so the usual way is to use one wire at column 4 to the common VCC line (and omit the second gren wire)
Same with GND.
Klaus