gnd and power routing polygons altium

Status
Not open for further replies.
K

khaled_3ttia

Newbie level 2
Joined
Mar 11, 2013
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,295
Hello,
I'm working on a design of 8 layers in Altium Designer and I made GND and power layers
I need to know how to router GND and power nets and how to use polygons with them
Thanks
 

Hi,
I am not sure here, are you using signal layer's for GND and Power. If this is the case why don't you use planes instead of layers for GND and Power.

Regards,
Anil
 

You need to add polygons for Gnd and power nets. Full flood ground layers without any splits.
you can use split planes in your power layers but make sure there are no critical signals running
above the power layers and crossing the splits.(i.e make sure you have reference for all critical signals)
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…