gnd and power routing polygons altium

[khaled_3ttia]

Hello,
I'm working on a design of 8 layers in Altium Designer and I made GND and power layers
I need to know how to router GND and power nets and how to use polygons with them
Thanks

 

[anilrock87]

Hi,
I am not sure here, are you using signal layer's for GND and Power. If this is the case why don't you use planes instead of layers for GND and Power.

Regards,
Anil

 

[SHABU]

You need to add polygons for Gnd and power nets. Full flood ground layers without any splits.
you can use split planes in your power layers but make sure there are no critical signals running
above the power layers and crossing the splits.(i.e make sure you have reference for all critical signals)