[SOLVED] GLCD Ampire 128x64 Display problem

//Code starts from here

#include <18F4550.h>

#DEVICE ADC=10

#fuses HSPLL,NOWDT,NOPROTECT,NOLVP,NODEBUG,USBDIV,PLL5,VREGEN,NOBROWNOUT
#use delay(clock = 48000000)

#include <math.h>
#include <HDM64GS12.c>
#include <graphics.c>

unsigned char buffer[3];
unsigned char Celcius[] = "Celcius";
unsigned char warning[] = "Warning";

void displayTemperature(unsigned int adc)
{
    sprintf(buffer,"%u",adc);
    glcd_rect(45, 38, 55, 45, YES, OFF);            // Clear the old voltage
    //The above line removes the old values on lcd
       glcd_text57(45, 38, buffer, 1, ON);            // Write the new voltage
       glcd_text57(70,38,Celcius,1,ON);
}

unsigned char name[] = "MY PROJECT";
unsigned char system1[] = "TEMP. MONITORING";
unsigned char system2[] = "SYSTEM!";

void main()
{
    unsigned int16 adc;
    unsigned int adc_old = 0;
    unsigned int16 i,j;
    int1 warn = FALSE;
    setup_adc_ports(ALL_ANALOG);
    setup_adc(ADC_CLOCK_INTERNAL);
    set_adc_channel(0);
    i=0;
    glcd_init(ON);
    delay_ms(10);
    glcd_rect(1,25,126,35,NO,ON);
    glcd_text57(70,38,Celcius,1,ON);
    glcd_text57(20,0,system1,1,ON);
    glcd_text57(45,10,system2,1,ON);
    
    while(1)
    {
        adc = read_adc();
        if(adc > 52)
        {
            adc = adc - 2;
        }
        else
        {
            //Don't do anything
        }
        adc = adc/2;
        displayTemperature(adc);
        delay_ms(10);
        
        //Bar Start From this code
        
        if(adc != adc_old) 
        {
            glcd_rect(adc + 1, 26, adc_old + 1, 34, YES, OFF);  // Clears the old bar
            glcd_rect(1, 26, adc + 1, 34, YES, ON);             // Draws a new bar
            adc_old = adc;
            
            if(adc > 40 )//&& !warn)            //Check if over 40 degree celcius
            {
                //Controller comes here when Temperature is greater than 40 degree
                //and warn is FALSE
                //warn is defined as FALSE in earlier part of the program
                //at the end of this loop warn is defined as TRUE
                //so that program doesn't comes inside this if statement again
                
                glcd_rect(5, 48, 126, 63, YES, OFF);   // Draw a filled black rectangle
                glcd_text57(25, 48, warning, 2, ON);  // Write "Warning" on the LCD
            }
             else if(adc <=40)// && warn)
            {
                glcd_rect(5, 48, 126, 63, YES, OFF);  // Draw a filled white rectangle
                glcd_text57(5,55,name,1,ON);                
            }              
              #ifdef FAST_GLCD
              glcd_update();
              #else
              delay_ms(100);
              #endif
        }
    }
}