optionfa
Newbie level 3
- Joined
- Oct 21, 2009
- Messages
- 3
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Location
- Toronto Ontario
- Activity points
- 1,312
I need to set up a switching signal to control my gate drive IC on the three phase inverter I am building.
The gate drive IC is the following: http://www.irf.com/product-info/datasheets/data/ir2136.pdf
I need a way of generating three PWM waveforms 120 degrees apart.. What would be the best way to generate these signals? I am not very good with MCU programing or DSPs, is there a waveform generator capable of generating 3 PWM waveforms triggered off each other?
This would be mostly for the testing phase.
Thanks.
The gate drive IC is the following: http://www.irf.com/product-info/datasheets/data/ir2136.pdf
I need a way of generating three PWM waveforms 120 degrees apart.. What would be the best way to generate these signals? I am not very good with MCU programing or DSPs, is there a waveform generator capable of generating 3 PWM waveforms triggered off each other?
This would be mostly for the testing phase.
Thanks.