Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

fully differential OP-AMP question??

Status
Not open for further replies.

wael_wael

Full Member level 4
Full Member level 4
Joined
Dec 3, 2005
Messages
221
Helped
5
Reputation
10
Reaction score
2
Trophy points
1,298
Activity points
2,760
hi every body,

for the FDA(fully differential OP-AMP) how to measure the gain and the phase, is it between for example the +vout and ground or +vout and -vout
regards
 

wael_wael said:
hi every body,

for the FDA(fully differential OP-AMP) how to measure the gain and the phase, is it between for example the +vout and ground or +vout and -vout
regards


differential gain = (Vout2-Vout1)/ (Vin2 Vin1)

You can use calculator function from Spectre to plot that graph.
 

    wael_wael

    Points: 2
    Helpful Answer Positive Rating
you can example the +vout and ground , but gain must increase +6dB
 

Gain is measured with difference of the positive and negative output terminal with referred to the input terminal.
 

use calculator to plot the wave of (Vout2-Vout1)/ (Vin2 Vin1)
 

db((Vo1-vo2)/(vi1-vi2)) gives u gain
phase ((Vo1-vo2)/(vi1-vi2))
 

simply apply an ac source with unit amplitude between the in+ and in- terminals . then plot the gain and phase of the difference between out+ and out- .
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top