Front-End Amplifier for multiple SAR ADC?

Status
Not open for further replies.
C

carpenter

Full Member level 6
Joined
Jul 25, 2012
Messages
358
Helped
22
Reputation
44
Reaction score
24
Trophy points
1,298
Visit site
Activity points
4,535
MCU as STM32F303 allows you to connect two ADC in dual mode. Two 12bit 5MSMPS work as a ONE 10Msps ADC.ST Unfortunately, no one does, how to solve Front-End Amplifier for ADC in dula mode.
Use one amp for both ADC or two for each ADC own amplifier?
 

One amplifier is likely better, otherwise any gain/offset mismatch between the multiple amplifiers will cause artifacts in the sampled data. You should spec the amp as if you were really driving a single ADC operating at 10msps.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…