anvc
Newbie level 6
- Joined
- Apr 18, 2013
- Messages
- 12
- Helped
- 0
- Reputation
- 0
- Reaction score
- 0
- Trophy points
- 1,281
- Activity points
- 1,367
Hello all,
I am trying to simulate the frequency response of a simple rectifier using HB in ADS (Vdc x Freq). I have set the sweep variable to be the frequency of the power source of the circuit. When I perform the simulation, however, I get a constant dc output voltage which does not depend on the input frequency. Normally the cut-off frequency of such rectifier should be around 1GHz. Anyone can give a hint here on how to perform this simulation?
Thanks!
I am trying to simulate the frequency response of a simple rectifier using HB in ADS (Vdc x Freq). I have set the sweep variable to be the frequency of the power source of the circuit. When I perform the simulation, however, I get a constant dc output voltage which does not depend on the input frequency. Normally the cut-off frequency of such rectifier should be around 1GHz. Anyone can give a hint here on how to perform this simulation?
Thanks!