jaycribs
Newbie level 3
Hi i need help the Verilog programming code...im supernew to Xlinx...but i already started my research abt the verilog program...i just really confused about where to start with the code.. My project is Using a Digilent BASYS FPGA board: Make a motor spin both directions
with variable speed that can be set with switches SW0 - SW7. The L298 Hbridge can be used. Care must be taken to protect the FPGA from excessive
current draw and large voltage transients.
Where do i start with writing the verilog code for this project. Thanks Guys
with variable speed that can be set with switches SW0 - SW7. The L298 Hbridge can be used. Care must be taken to protect the FPGA from excessive
current draw and large voltage transients.
Where do i start with writing the verilog code for this project. Thanks Guys