FPGA Schematics for PCI card

[sailor_eda]

fpga schematic

I know this is a fairly broad question but does anybody have a good design for a PCI card for FPGA design prototyping?

Sailor_EDA

 

[mystery]

pci card schematic

Here is the schematic for the Altera cyclone fpgas

 

[Ahmed Ragab]

pci post card schematic

Here is the schematic for the @ltera cyclone fpgas

Would you kindly explain what this schematic represents, I got totally lost and cant' figure out much of it.

Thanks in advance, Salam.

 

[mystery]

cyclone pci schematic

Here is the schematic for the @ltera cyclone fpgas

Would you kindly explain what this schematic represents, I got totally lost and cant' figure out much of it.

Thanks in advance, Salam.

it is an PCI card schematic which is designed for cyclone FPGAs

 

[sailor_eda]

pci controller schematic

Mystery,

Thanks for response. This will come in very handy.
Would you happen to have any similar schematics for Xilinx Virtex II by any chance?

Thanks again

Sailor_EDA

Here is the schematic for the @ltera cyclone fpgas

Would you kindly explain what this schematic represents, I got totally lost and cant' figure out much of it.

Thanks in advance, Salam.

it is an PCI card schematic which is designed for cyclone FPGAs

 

[mystery]

pci schematic card

Hi to all

I've found a schematic for Avnets' Spartan 3 PCI Card. Enjoy it

 

[bubu321]

pci fpga schematic

hi,
- PCi card on xc2s100 PQ208, controller for HDD drive.

**broken link removed**

 

[chiara]

fpga schematics

0. place FPGA near to the edge of the board.
1. print out FPGA pin map.
2. print out PCI pin list and draft.
3. assign the fpga pin to PCI pin (short distance is number 1 rule). use dedicated bank for PCI. well use separate vcco for the bank if possbile.
4. if you need host power for add-in card(FPGA board), add de-caps on power pins
5. if you don't need host power, cut off power lines (to protect FPGA from accident)
6. pull-up several control signal pins(refer to pci spec) - optional.

if the distance from the edge of the board is short enough, you don't need the trace length equalization.

* I think that general connector and custom riser card pair is easier to handle.
you will not be limited to make the board 1.6mm thick.
* on Avnet board, they use buffer ICs for signal lines, but I don't think they are needed.

 

[malcolm_119]

pci card schematics

all of them are valuable references

 

[heshuaidd]

pretty useful , thanks!!!