Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Flicker Noise Cutoff Frequency

Status
Not open for further replies.
D

dolgaleb

Member level 2
Member level 2
Joined
Nov 9, 2008
Messages
42
Helped
0
Reputation
0
Reaction score
1
Trophy points
1,288
Activity points
1,679
I am in the process of doing a phase noise analysis in a downconverter and need to know the flicker noise cutoff frequency of the devices in the chain. Where do I find this information?
 

Sort by date Sort by votes
In the component respective data sheet in the signal chain ?

Attached a paper.


Regards, Dana.
 

Attachments

  • 1001.2047.pdf
    2.6 MB · Views: 191

Upvote 0 Downvote
Classic 1/f with noise corner (where broadband noise takes over as predominant) :

1669289598225.png



Regards, Dana.
 
Last edited:

Upvote 0 Downvote
not too many spec sheets will actually list flicker noise or residual phase noise.
you might have to make your own measurements.
obviously, choosing the right type of transistor will go a long way. Silicon bipolar is king
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top