Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

filter insertion loss and cavity face smooth

Status
Not open for further replies.
Current flows in the metal surfaces. If the surface has undulations on it, the current travels over a longer distance at a given skin depth. This causes more (I^2)R loss. Also the cracks in the surface cause problems. Some platings that you would think of as low resistance have cracks and so have higher resistance.
 

    A

    amicloud

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top