Field monitors on plane wave HFSS

Status
Not open for further replies.
J

JohnFid

Junior Member level 3
Joined
Oct 22, 2012
Messages
29
Helped
2
Reputation
4
Reaction score
2
Trophy points
1,283
Location
Greece
Visit site
Activity points
1,474
Hello,
I implemented on HFSS the structure below and I want to monitor fields between patch and ground in various frequencies, in a range over a band gap zone. I managed to produce the bandgap zone by using HFSS's eigenmode solver. To monitor fields do I have to change the solution type? If yes, what type of port must I use? Plane wave or floquet port? Moreover, what about the boundaries and the airbox that I should use (etc height)?
Thank you.


 

hi.
If your purpose is to show the fields in your structure,I know how it is done.
in my design, i used wave port,solution type:driven modal,i had a radiation boundary.
After selecting the desired part of design, you should this steps:
right click-plot fields-select E or H or...
and then HFSS-fields-animate to see the wave motion.
I hope, helped you.
Good Luck
 

First of all thank you for your answer.
Where exactly did you assign the excitation? On the top of the radiation boundary's box? How big that box was? Why did you use waveport instead of plane wave?θ
Do you have any project-example to follow?
Thank you again.


This is my project:
View attachment cell2.zip

I used PML boundaries and a waveport for excitation. I don't know if it correct. I want to monitor far field for frequencies over a bandgap which produced by the same
structure on eigenmode.
 
Last edited:

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…