feedback to a class AB push pull amplifier

Status
Not open for further replies.
A

analog_chip

Full Member level 1
Joined
Oct 9, 2011
Messages
99
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Activity points
1,994
Hi,

I have a class AB push pull amplifier shown below. It has single ended input and single ended output.

1.How can I give a resistive feedback and use it.

2.How can i measure input common mode range and output common mode range?

3. How can I measure offset voltage? Is there any significannce of offset voltage in case of single ended input and output?

Thanks

 

Hey Dude!
Hi
I think Your circuit is at CLASS B amplifier because your gates has not dc bias for GS. for feed back: do you wanna get negative feedback?
if yes , do you have voltage amplifier in preceding of your power amplifier? and what is the range of your BW?
though for having a negative feed back in this types of amplifiers , you have many simple way.
if your amplifier has voltage driver amplifier out of phase(180 degree) your feed back is very simple. you will can get feed back with a simple voltage devider and one capacitor. and if your amplifier is in phase you can use phase inverting amplifier feed back with a simple op amp or CE amp.
All the best
Goldsmith
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…