Ethernet module using ENC28j60

[susmimu]

Dear Sir,
I have developed a home automation project using both IR and RF remote control which is used to:

1. ON/OFF room lights and fans
2. Speed control for fans

Now I want to do the works remotely over internet.
I already made the hardware (Ethernet module using ENC28j60) without firmware. Now I need the firmware for Ethernet module. Could anybody help me by giving the firmware in C language.
Please give full code if anyone did such project, or full code for Ethernet module.

Regards
Hasan

 

[madhusuthanan]

which controller do you going to use?

 

[susmimu]

I am using ATMEGA16. I am ready to change model if necessary. I think ATMEGA16 will not suitable as its memory is smaller.

 

[madhusuthanan]

first visit this link.
https://www.edaboard.com/threads/269927/

 

[susmimu]

Thank you
I see its a good link

Thanks again