hi i made ENC28J60 Circuit by Proteus
1- is it true? what's the terminal I need it to connect it with PIC?
but I don't found RJ45 connector .I made it ....is the package terminal true?
2- what's the configuration network I need to connect with circuit??
To implement an Ethernet module requires much more than a simple RJ-45 Jack, signal transformers combined with an array of discrete compoments, capacitors and resistors are necessary to complete the design.
The follow is a detailed schematic of a typical implementation:
Many of the components enclosed in the red box, comprise what is commonly referred to as the magnetics.
There are RJ-45 jacks available which include the magnetics, like the MagJack which is available in numerous configurations, therefore care must be taken to select a model compatible for use with the ENC28J60.
The following is a schematic for the
Ethernet PICtail Plus Daughter Board (AC164123) which uses a MagJack:
As far as implementing/simulating an ENC28J60 in Proteus, I'm not sure what RJ-45 Magnetic Jacks are available, if use of discrete components are necessary or Proteus simply doesn't care.
Another possible example of how simulations differ from physical hardware.
Therefore, you should be aware if you intend on implementing a viable ENC28J60 design in hardware additional steps are required.
BigDog