Error when simulating ridged conical horn in HFSS

Status
Not open for further replies.
S

sayan4

Newbie level 5
Joined
Oct 31, 2005
Messages
9
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Activity points
1,364
Hi i have a problem with HFSS.I'm studying a ridged conical horn using HFSS.I have drawn if and I have drawn the box where I have put antenna.When I have started simulation an error message appears
" [warning] Solution Setup 'Setup1': Given the specified frequency and model dimensions, an extremely large mesh will be required to produce an accurate solution. Your model and/or frequency units may be set incorrectly"

I have used a bandwidth that goes from 2 GHz to 9Ghz.
How can solve the problem?
Please help me.I'd like to know where I could find such articles about ridged conical horn and its simulation with FEM
Thanks and excuse me for my english,but I'm italian
 

HFSS help

You can draw your model.then maybe some suggestion can be given.
 
Re: HFSS help

this is my model

Added after 1 minutes:

Excuse me.How can I draw my model?
 

Re: HFSS help

hi, sayan4
im getting the same warning as u...though my freq is 300GHz.Did u find out a solution to this problem...please suggest me
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…