error in layout to schematic conversion in ADS

Status
Not open for further replies.
N

nauma naseer

Junior Member level 3
Joined
Dec 22, 2008
Messages
26
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,283
Visit site
Activity points
1,479
Hi,,, I had design an Antenna in Momentum layout and rectifier in schematic. I import layout to schematic following method momentum.....Component... Create updated .. after this i select lookalike option with minimum pin to pin distance .... when i connect this with rectifier to find S-parameters it gives an error message(error message and design screen short is attached )
 

Attachments

  • design.png
    88.8 KB · Views: 117
  • error message.png
    67.8 KB · Views: 93

Some comments:

Have you completed a standalone Momentum simulation on the antenna network yet? This would show that the EM simulation was set-up correctly before attempting the co-simulation in the schematic.

It looks like the wire connecting from C1/C4/C5 and the antenna has a red indication on the antenna end. This indicates that it is not connected to anything.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…