Error in launching to hardware in SDK

Status
Not open for further replies.
G

Gayathrirani

Newbie level 4
Joined
Jul 11, 2014
Messages
7
Helped
1
Reputation
2
Reaction score
1
Trophy points
3
Visit site
Activity points
73
I am trying to implement a LED blinking program using EDK.I have selected GPIO LEDs(datawidth 8) and updated UCF files.When i try to launch it on hardware ,the error "MicroBlaze is under reset.Check if the reset input to MicroBlaze and its Bus interfaces are connected prpoerly" appears.I am using Genesys Virtex-5 board and for reset input i am using a push button(G7) since there's no LOC for reset given in the .ucf.
I get the warning message also in EDK.
"WARNINGar:288 - The signal dlmb_LMB_ABus<30> has no load. PAR will not attempt to route this signal.
WARNINGar:288 - The signal dlmb_LMB_ABus<31> has no load. PAR will not attempt to route this signal."
How to solve this issue?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…