Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

error frame in can communication

Status
Not open for further replies.

debabrta kar

Member level 5
Member level 5
Joined
May 20, 2013
Messages
86
Helped
7
Reputation
16
Reaction score
5
Trophy points
1,288
Location
india
Activity points
1,858
i am doing can communication using at89s8252,mcp2515,pca82c250..actually i donot have any can tool to visualize the bits and i have a doubt that there are how many bits in active error frame and passive error frame. please suggest and explain .also please suggest how a node on can bus distinguish between active error frame and overload frame because they both have same configuration..thank you
error frame in can communication
 

The recommendation is to check you CAN wave form with some debug tools.
check the wave is right or not.You can send data bit by bit, check it bit by bit,then find out the error.
 
yes i have to check bit by bit but can you please expalin about error frame and overload frame , how to differentiate them....
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top