Eprom copying USINTG PROGAMMER ELNEC SMART PROG 2

Status
Not open for further replies.
Surely you just "read" the first device, replace it with the second device, change the device part number and select "program"? You may need to save the "read" data to the PC in between if the software clears the memory on a device change, in which case you then need to reload the data from the PC.

Keith
 


I have done above procedure but did't successful .When second device is inserted in cct. the display shows blank or blank square strip.
Should address of EPROM ST 27C512 is to be changed or any other changes.
 
Last edited by a moderator:

I think's it can not be done.
because data input is different.
 

Attachments

  • Data Input.pdf
    79.6 KB · Views: 83

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…