Epoxy problem solved I think

Status
Not open for further replies.
B

boylesg

Advanced Member level 4
Joined
Jul 15, 2012
Messages
1,023
Helped
5
Reputation
10
Reaction score
6
Trophy points
1,318
Location
Epping, Victoria, Australia
Activity points
11,697
After a bit of research I have found that epoxy coating systems are a common in marine boating.

They come as a two part paint and hence will flow much more readily than araldite glue. And it seems I might be able to get them in quantities as small as 500ml (250ml + 250ml) to try out.

And there is a retail boating store not far from me.
 

I'm not sure what the problem is that you were trying to solve, but yes epoxy resin comes in a liquidy form too -
it is as thin as water pretty much, and when mixed will stay like that for about 24 hours (unlike araldite).
If you're pouring it into a mold, then it needs to have absolutely no holes/gaps in the mold for 24 hours unless you want the
liquid on the floor ; ) Don't say I didn't warn you!.
Oh - and it needs to be mixed extremely well, otherwise it will never set, and will be next to impossible to clean off.
One way of mixing is a very slow-running electric drill (otherwise you'll get air bubbles) with a mixer attachment which could
just be a thick piece of wire made into a circle at the bottom I suppose.
And when it is in the mold, leave it in a warm place for the 24 hours or whatever period is recommended.
 
Last edited:


I have also read that you can get water based epoxy systems, which would make clean up rather easy. Hopefully I can get hold of a water based epoxy paint. And you can get additives that thicken the paint in order for it to bridge gaps and fill holes.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…