Encoder pin assignment of Bosch Servodyn-D servo motors

Status
Not open for further replies.

dilzam

Newbie level 2
Joined
Oct 20, 2014
Messages
2
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
18
I have two Servodyn-D servo motors [SF(R)–A4.0230.060]. When connecting power to the encoder(ECN1313), do we have to supply +5V from an external power source? Or the motor has its own +5V power supply to provide the power to the encoder ?. I believe that we need to input power to +5V and 0V pins. We don't have to power 5V(sensor) right? Could you please correct me if I am wrong.

What are the R+ and R- Reference signals in following encoder pin out diagram? ( There are two pins called- timing). I have attached the diagram here(Figure1-Encoder Pinout).>>>

And what does two "data" pins and two "timing" pins exactly do?. My intention is to connect the 17 pin Bosch encoder cable to 12 pin connector of the Heidenhain IBV 610 unit. I have attached the diagram here(Figure2 (Pin Diagram))>>>

The needed datasheets(Motor datasheet and Heidenhain Interpolation and digitizing units) also attached herewith.

Thank you.
 

Attachments

  • Bosch Motor_datasheet-06602403.pdf
    1.2 MB · Views: 205
  • ECN 1313_STG Heidenhain encoder_Bosch motor.pdf
    2.3 MB · Views: 292

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…