roger 6010
Hi, I have a question about the edge-mounting connector for 25 mil roger 6010 board.
Since the 50 ohm microstrip line width is about 0.6mm, it seems the pads for the single pin of connector should be larger than the microstrip line width. However, I found that in the HFSS simulation, the wider the signal pin pad, the higher insertion loss and VSWR. And my best simulation insertion loss is about 0.7 dB and VSWR is 1.7 at 7~8 GHz.
My question is that is it the real-world case for the edge-mounting connector? How can I do to lower the VSWR and insertion loss?
Thanks.