edge detection model not working in hardware virtex2pro board

Status
Not open for further replies.
S

sushanti123

Newbie level 4
Joined
Feb 5, 2015
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
27
My edge detection model simulation works fine in system generator for software part and displays the output but after generating hardware cosim block and running the same model using virtex 2 pro board does not give any error but does not display the output at all.

Can any one help me out to figure out the problem?
 

Sorry I broke my crystal ball and can't see your code.
 

Sorry, I have attached the models

- - - Updated - - -

Files are attached
 

Attachments

  • model.zip
    22.1 KB · Views: 55
  • model (2).zip
    23.4 KB · Views: 56

Your code is only readable for Xilinx System Generator users that have the respective toolchain installed.

To see why "doesn't work", we would need to look at the generated HDL.
 
The hardware implementation of this model results in a black screen instead of an output image. Please help me to figure out this problem
 

Im sorry, this is just too large and hard to understand project (because of the generated code).
I cant really help, because the real problem probably comes from the design, not the code. And I dont have ISE system generator to look at this.
How have you tested this? is there a good testbench?
Have you had a look at the output on a scope? Is it just some DC voltage? is there some attempt at a video waveform?
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…