Eagle schematic and layout editor

Status
Not open for further replies.

imranahmed

Advanced Member level 3
Joined
Dec 4, 2011
Messages
822
Helped
3
Reputation
6
Reaction score
3
Trophy points
1,298
Location
Karachi,Pakistan
Visit site
Activity points
6,533
Please let me know that how to make schematic and layout in the Eagle Software.

Can anyone interested to tell me?
 

Please let me know that how to print only bottom side of PCB in eagle.When i was printing PCB the top side of
PCB print with bottom side.How to print only top or bottom side?
 

If I want to make PCB, that is only bottom side and make jumpers automatically,is it possible or not,please let me
know about that.
 

imranahmed said:
If I want to make PCB, that is only bottom side and make jumpers automatically,is it possible or not,please let me
know about that.
Click to expand...



this is an example
1) click on auto route and deactivate the top layer (select N/A) then click ok
2) if there is un routed wires click in manual route (route) and move with the bottom track till reach to the tracks u want to jump then change the layer to the top layer through the top selector of the page beside the grid icon.

if u have any question, i wish to help u
Regards,
Hz
 
Don't autoroute. The example shown can easily be routed manually without using the top side of the PCB. You will learn a lot more about component placement (which is critical for good layouts) if you manually route.

Keith
 
The component placement is poor. For example, R4 connects between pins 1 and 7&16 of the IC so it should be near pins 1&16 or 1&7. Placement should always be done to minimise track length and crossovers.

Keith
 
Hello, Guys
It is just an example and it is not represent actual circuit, and i know also that i can have a bottom track instead of the top jumper
but, he wants to know that. So, i made that simple example.

Regards,
Hz
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…