T
treez
Guest
Hello
I just ran the ULP called "drilllegend.ulp", selecting "run in board"...however, a list of drill diameters and their dimensions did not appear, and it gave me an error message, "Cannot find IT _.scr"
...I cannot understand this, and the manual, eg on page 283, says nothing of it. This always used to work for me, but now it is not providing the drill list. Do you know why?
I just ran the ULP called "drilllegend.ulp", selecting "run in board"...however, a list of drill diameters and their dimensions did not appear, and it gave me an error message, "Cannot find IT _.scr"
...I cannot understand this, and the manual, eg on page 283, says nothing of it. This always used to work for me, but now it is not providing the drill list. Do you know why?