pilko
Junior Member level 3
Hi everyone,
When I autoroute in Eagle, the traces extend into the center of pads and vias. Copper is therefore filling the drill hole locations making it difficult to position the drill bit to the center of the hole. I have to manually shorten the traces to the perimeters of the pads and vias.
Can anyone please explain why it does this and what I can do to prevent it.
When I autoroute in Eagle, the traces extend into the center of pads and vias. Copper is therefore filling the drill hole locations making it difficult to position the drill bit to the center of the hole. I have to manually shorten the traces to the perimeters of the pads and vias.
Can anyone please explain why it does this and what I can do to prevent it.