Draw the output voltage waveform for firing angle of =150

Status
Not open for further replies.
S

sina shekari

Newbie level 4
Joined
Nov 21, 2013
Messages
6
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Visit site
Activity points
36
There are 4 SCR and 2 diode.
After drawing the output voltage I would be grateful if someone could calculate the Mean voltage.
 

There are 4 SCR and 2 diode.
After drawing the output voltage I would be grateful if someone could calculate the Mean voltage.
Click to expand...

Hi Sina
In your case out put voltage ( average ) can be easily calculated by the formula : sqrt(1/T integral over Vm^2 sin wm^2 dt ) from zero up to the firing angel .

But of course i hope you know if the load is inductive then the firing angel would be affected and will be changed and calculation needs more patience .

Best Wishes
Goldsmith
 

this formula is for RMS...
can you drawing the output voltage?
 

this formula is for RMS...
can you drawing the output voltage?
Click to expand...

Hi
Oops ! sorry yeah you're absolutely right i wanted to write RMS but my typo .

Anyway , average formula is this : 1/T integral over Vs dt from zero up to firing angel .

Good Luck
Goldsmith
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…