Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.
It has. The standards for ESD sets voltage levels and source characteristics (such as human body model (HBM) or machine model (MM) ). Both the model and the voltage level may be specified in the product's datasheet.
It has. The standards for ESD sets voltage levels and source characteristics (such as human body model (HBM) or machine model (MM) ). Both the model and the voltage level may be specified in the product's datasheet.
The figure of merit is the voltage*model that the device
withstands. Some newer standards even require that it
withstand multiple strikes. There are "Class" bins that
group ESD susceptibility; if you're a manufacturing dude
you may simply want to know that the assembly floor's
ESD threat level is lower than the lowest "Class" part to
be handled, not each one's specific HBM rating.
And of course any / all of this could have been yours
for the Googling, while you were waiting for answers
to be served.
This site uses cookies to help personalise content, tailor your experience and to keep you logged in if you register.
By continuing to use this site, you are consenting to our use of cookies.
