hobbskw
Junior Member level 3
Hello, I have been trying to figure out if I need to put decoupling capacitors next to the IO pins of my FPGA. It is a Zynq 7000. I checked their hardware design guide and couldn't find an answer, as well as several other forums. The Zynq guide says to either place a 4.7 uF within two inches of the edge of the chip, or a 0.47 uF within half an inch. But it doesn't specify which pins these should be linked to. Everyone mentions that power supply pins should have them, like VCC, but no mention of IO pins. I appreciate any help!
Zynq guide I am referring to is here: https://www.xilinx.com/support/documentation/user_guides/ug933-Zynq-7000-PCB.pdf
Zynq guide I am referring to is here: https://www.xilinx.com/support/documentation/user_guides/ug933-Zynq-7000-PCB.pdf