DIY Power Amplifier load tuning

Status
Not open for further replies.
A

aaron_do

Member level 3
Joined
Dec 12, 2007
Messages
64
Helped
4
Reputation
8
Reaction score
3
Trophy points
1,288
Visit site
Activity points
1,878
Hi all,


I have a PA design where I need to do some load optimization. A manual load-pull may be an option, but I expect it might be pricey.

I was wondering if anybody has any good DIY options. I was thinking to follow the PA with a hybrid coupler and a variable load at the main output port (port 2 normally). I can then sense the forward power signal at port 4. The variable load could be just a parallel RC or RL.

Anybody have better ideas?


thanks,
Aaron
 

A 3 dB hybrid splitter will normally lose 3.5dB but <1dB when 1 port is unloaded such as with a high impedance diode cap forward or reverse power detector. Return loss performance is adjust if loaded correctly.

But then you can use it as a directional coupler to measure effects of variable load on return loss. A 75 Ohm hybrid can be modified to 50 Ohm by changing the balance 2xR inside the splitter.
 

Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…