gregoryt
Newbie level 1
Hi all!
Have been struggling to make, my 1st "serious" DIY electronics project, a bench PSU out of a PC ATX PSU for about a year now. I'm in the place where everything are up to be built, but have some difficulties understanding some things (I'm a rookie and hobbyist in electronics, just learning). I have created the project in KiCAD based on the very good PSU described here which is an awsome concept but had a few errors which I repaired eventually. I have attached the KiCAD files and the arduino code of what I made, I would really appreciate any comments or suggestions to make it as good as it can be! Please be aware that I'm a complete amateur and very new to the electronics world! Thank you and best regards!
Gregory
Have been struggling to make, my 1st "serious" DIY electronics project, a bench PSU out of a PC ATX PSU for about a year now. I'm in the place where everything are up to be built, but have some difficulties understanding some things (I'm a rookie and hobbyist in electronics, just learning). I have created the project in KiCAD based on the very good PSU described here which is an awsome concept but had a few errors which I repaired eventually. I have attached the KiCAD files and the arduino code of what I made, I would really appreciate any comments or suggestions to make it as good as it can be! Please be aware that I'm a complete amateur and very new to the electronics world! Thank you and best regards!
Gregory
