jasiek
Newbie level 2
Hey,
I'd like to install a couple of analog sensors (temperature, mostly) in my house. What I'm looking for is a simple way to connect them so that I can read the state of each sensor through a bus of some sort. Ideally, I'd like to connect a 4-wire cable to each sensor and read them through a microcontroller board like the Arduino.
I've looked at both I2C and 1-Wire, but both seem to have a range which is too short for my scenario.
What should I use here?
Thanks,
jan
I'd like to install a couple of analog sensors (temperature, mostly) in my house. What I'm looking for is a simple way to connect them so that I can read the state of each sensor through a bus of some sort. Ideally, I'd like to connect a 4-wire cable to each sensor and read them through a microcontroller board like the Arduino.
I've looked at both I2C and 1-Wire, but both seem to have a range which is too short for my scenario.
What should I use here?
Thanks,
jan