[SOLVED] Discontinuous Buzzer circuit !

Status
Not open for further replies.
K

kunaltg

Member level 2
Joined
Nov 4, 2010
Messages
45
Helped
1
Reputation
2
Reaction score
1
Trophy points
1,288
Visit site
Activity points
1,598
Hello guys ,i have brought TMB12A05 Buzzer ,,Its sound is good but its continuous !!

I want to make it discontinuous, but without any controller or IC ,,I just want know if there's an analog circuit for making it discontinuous !!

I want it to be as small as possible !! is it possible to do it with some combination of cap & diode ??
 

Yes it can !! but i don't want to use any IC !! I want it as small as possible !! is it possible ??
 

I don't think it will be easy with passives, and they will be bigger than a 555 anyway.

The only thing I can think of is a tunnel diode oscillator which I have never used, but think they are more HF areas.
You need something that will charge up and then discharge.
If you are lucky the piezo could be high impedance across the supply pins while off and go low impedance when on.
Then you could try and RC circuit with Piezo across the C. It would allow the volts to rise and then burst into song until the volts drop, return to high impedance allowing the C to charge.
It seems unlikely, but give it a try?
 
A flasher led has a miniature oscillator inside it. If the buzzer does not draw too much current you can put it in series with the flasher led.

Or add a transistor if it uses a lot of current. Use the flasher led to bias the transistor.
 
I like BradtheRad's suggestion, this is a neat idea to investigate.

Incidentally, those "flickering tea light" that you see around are the opposite, they use sound chips to drive the led with the music!
 
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…