nenou_renardo
Newbie level 1
designer edges do not define a valid port ansoft
Hello,
I'm trying to design a dipole antenna with ansoft designer.
This dipole must be connected to RFID CHIP.
Lambda/4 Lambda/4
=======[]=======
RFID
CHIP
I've separated the dipole into two rectangle of lambda/4 (0.1mm separate them) and i've selected the edges and add a port but the software say "edges do not define a valid port".
In the help, i've found that:"The edges must be co-linear"
How can i simulate it???
Thanks You for your future Help
Hello,
I'm trying to design a dipole antenna with ansoft designer.
This dipole must be connected to RFID CHIP.
Lambda/4 Lambda/4
=======[]=======
RFID
CHIP
I've separated the dipole into two rectangle of lambda/4 (0.1mm separate them) and i've selected the edges and add a port but the software say "edges do not define a valid port".
In the help, i've found that:"The edges must be co-linear"
How can i simulate it???
Thanks You for your future Help