Diameter of PQ3535 former

Status
Not open for further replies.
T

treez

Guest
Hi,
We are trying to work out the diameter of the PQ3535 bobbin, drawing shown on page 3 of the datasheet (below).
Would you say it is 75mm/pi = 23.87mm?

There is a number given as 14.7mm, but this does not appear to be the actual diameter?

PQ3535 datasheet
https://ferroxcube.home.pl/prod/assets/pq3535.pdf
 

The diameter isn't specified in the linked drawing. Look out for appropriate manufacturer data, e.g. this **broken link removed**

 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
14.7 for the bobbin ID ....
--- Updated ---

16.9 for the OD ...
--- Updated ---

31.4 for the outer round part ....
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Hi Treez,

It's cool that FvM dug up the dimension. I didnt take the route that FVM took though. However, I got approx the same figure. I did some calculation based on the dimensions given on the datasheet you presented and I got 16.3mm for the OD.
 

    T

    Points: 2
    Helpful Answer Positive Rating
the diameter of PQ3535 can be easily find using digital varineir caliper. its about 14.4mm
or 1.44cm.
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Akanimo said:
...
I did some calculation based on the dimensions given on the datasheet you presented and I got 16.3mm for the OD.
Click to expand...
Just to show what I did.

Average length of turn MLT = 75mm ...(1)
MLT = (circumference of rim + circumference of bobbin)/2 ...(2)
Dia of Rim = 31.4mm
Therefore circumference of rim = π×(dia of rim) = π×31.4mm = 98.64mm ...(3)
Substituting (1) and (3) in (2) and solving for circumference of bobbin,
circumference of bobbin = (2×75mm) - 98.64mm = 51.35mm
Diameter of bobbin = (circumference of bobbin)/π = 51.35mm/π = 16.3mm
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…