are measured for the maximum load of the FPGA on the SP605 board which consists of a lot of components that are connected to the FPGA so it will need this amount of current, But the board I am designing is a simplified SP605 board, so I think I will not need these current ratings ?!
My board will contain mainly:
FPGA + DDR3 + SPI Flash + USB/JTAG + DVI Tx.
Hi Fusion,
I would say, you can calculate with so 4-6Amps(for 1.5 & 2.5V), but its ONLY FEELING!
You must search on Xilinx homeside for "Power Estimator" (or called similarly)!
With it you will become relative good/real values for your dynamic working system!!
Goodluck!
K.