Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

Debug Mode/Program Mode PIC 32MX

Status
Not open for further replies.
U

urakhai911

Newbie level 6
Newbie level 6
Joined
Apr 15, 2010
Messages
13
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,281
Visit site
Activity points
1,413
Hey World,

My question is regarding the debug mode on the PIC32mx. I am experiencing a peculiar situation where certain variables are the correct values in debug mode but in program mode they are all set to zero. I was wondering if you guys have experienced any issues regarding debug mode and the normal operation of the PIC.

-Vishal
 

I don't tend to use debug mode but have never noticed any problems with normal mode.
are you using a development board or your own PCB?
are the variables global or automatic initialised at RESET and then loose the values or are you doing calculations and then values are being lost?
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top