[SOLVED] DC supply becomes sawtooth when LOAD is applied

Status
Not open for further replies.
J

jishnuprakash

Junior Member level 2
Joined
Feb 21, 2022
Messages
22
Helped
0
Reputation
0
Reaction score
0
Trophy points
1
Activity points
144
hi,
I observed this problem in one of my devices which basically sense water and turns on a valve
problem is when the valve turns on supply to the coil becomes saw tooth
before

After

what could be the problem , we are using a SMPS 230VAC to 24VDC and Flyback transformer
has 2 output one 24V and other 15V , 24V is driving only this coil and an LED
15V is used to power microcontroller parts,

 

Sort by date Sort by votes
You didn't show power supply primary side, so we can only guess. Are you sure that the solenoid is permanently enabled during the test, not switching with about 160 Hz?
 

Upvote 0 Downvote
FvM said:
You didn't show power supply primary side, so we can only guess. Are you sure that the solenoid is permanently enabled during the test, not switching with about 160 Hz?
Click to expand...
the image you are seeing is when solenoid is enabled video below shows how signal changes
Your browser is not able to display this video.
the video below shows
 

Upvote 0 Downvote
given the time base in the mS region - there is not enough bulk storage on the mains side of the switcher - of the solenoid is overloading the output you are using ... (?)
 

Upvote 0 Downvote
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…