DC Motor Problem using mosfet

Status
Not open for further replies.

WhyWhy

Member level 4
Joined
Mar 18, 2013
Messages
68
Helped
0
Reputation
0
Reaction score
0
Trophy points
1,286
Visit site
Activity points
1,779
Hi guys,

I just wondering why need to use the resistor 4.7k ? It cannot direct supply to the PMOS gate without any resistor?
 

It cannot direct supply to the PMOS gate without any resistor?
You probably can, depending on the control voltage source.

Two points should be considred however
- you don't want to leave the gate terminal floating
- if you supply a higher voltage than +/- 20V between gate and source of the MOSFET, the transistor will immediately destroyed. It looks like this might happen in your circuit.
 


My motor unable to move if i not supply 60V to the Transistor between gate and source. Got any idea to prevent the transistor destroyed with 60V supply. Thanks...
 

Status
Not open for further replies.
Cookies are required to use this site. You must accept them to continue using the site. Learn more…