DAC that does not have a serial connection?

Status
Not open for further replies.
T

treez

Guest
Hello,
We wish to use a DAC but do not wish to communicate numbers to it via serial protocol.......we just want to 'bit bash' the numbers into it, -are there any DAC IC's that operate like this?
 

They are called parallel input DACs like this:
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Thanks but it needs too many pins.....surely there must be some DAC into which you can clock a digital value,by pulsing a "send" pin to say you are sending, then send a bit, then pulse send again to say you are sending the next bit, and then at the end of all that, say "bit sent" with another pulse to a pin........"bit bashing"...surely there are chips out there that go like that?
 

Yeah they are serial DACs...which you don't want to use?

You can bit bang a serial DAC with whatever protocol it wants, why is that a problem?
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
the datasheets don't explain the protocol...they expect you to just hook up a serial port module of a micro and just let it all happen
 

Every SPI DAC I have ever seen has a timing diagram somewhere in the datasheet, these are usually very simple devices (Clock, Data and a chip select).
The I2C parts are a little more complex to bit bang but you save a pin.

Regards, Dan.
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
if you look at device documentation you will often find sample code, e.g. Microchip's MCP4922 12bit DAC with an SPI interface
https://www.microchip.com/wwwproducts/Devices.aspx?product=MCP4922

even if the code is not for the microcontroller to be used as the host it can be useful as a guide to setting up control registers and loading data registers etc
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
As already mentioned, "bit bash" is obviously a serial connection and follows a protocol. In so far the thread title is completely misleading.

The minimal requirements for a "bit bashing" interface are a data line, a clock line (telling when the next should be read) and a sync line (marking either the first or the last bit). A basic SPI interface has just these three interface lines.
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Hi,

the datasheets don't explain the protocol...
Click to expand...

What DAC and datasheet are you talking about? Manufacturer name and device name.


Klaus
 
Reactions: treez

    T

    Points: 2
    Helpful Answer Positive Rating
Status
Not open for further replies.

Similar threads

Menu
Log in
Register
Cookies are required to use this site. You must accept them to continue using the site. Learn more…