lkminz
Member level 4
Hi everyone,
I am facing a strange issue with CST simulation.
simulation get stuck at some steps, like CAD modeling, and do not proceed further.
I am not sure is it because of my model or anything else.
I am making a patch antenna with air dielectric so there are small air gap between patch and feedline at some places. smallest gap is of 0.2 mm.
I used CST 2022 and CST 2023 version and it happens in both version. I am working on workstation so system configuration is also high.
I increased the mesh to 40 and some time 50 which makes it to complete the simulation but after few successful run simulation getting stuck at some steps.
in progess message it shows "... 100% CAD finished..." but nothing happens after that.
any suggestion or recommendation to avoid such issue please?
Thank you.
I am facing a strange issue with CST simulation.
simulation get stuck at some steps, like CAD modeling, and do not proceed further.
I am not sure is it because of my model or anything else.
I am making a patch antenna with air dielectric so there are small air gap between patch and feedline at some places. smallest gap is of 0.2 mm.
I used CST 2022 and CST 2023 version and it happens in both version. I am working on workstation so system configuration is also high.
I increased the mesh to 40 and some time 50 which makes it to complete the simulation but after few successful run simulation getting stuck at some steps.
in progess message it shows "... 100% CAD finished..." but nothing happens after that.
any suggestion or recommendation to avoid such issue please?
Thank you.