Continue to Site

Welcome to EDAboard.com

Welcome to our site! EDAboard.com is an international Electronics Discussion Forum focused on EDA software, circuits, schematics, books, theory, papers, asic, pld, 8051, DSP, Network, RF, Analog Design, PCB, Service Manuals... and a whole lot more! To participate you need to register. Registration is free. Click here to register now.

Register Log in

CST lumped components

Status
Not open for further replies.
F

f_t

Member level 4
Member level 4
Joined
Jun 30, 2014
Messages
75
Helped
1
Reputation
2
Reaction score
1
Trophy points
8
Activity points
633
Hello,

I am designing an antenna which has some lumped components like resistors. One of the resistors is connected between two strip lines. When I sweep the width of the strip lines, because size of the antenna changes, the resistor is not connected to the strip lines anymore and is somewhere even far from them. Is there any solution for it?


Thanks
 

Status
Not open for further replies.

Similar threads

Part and Inventory Search

Welcome to EDABoard.com

Sponsor

Back
Top